Description
The F-tone Networks FTCQ-5X6-SR4xx is a Four-Channel, Pluggable, Parallel, Fiber-Optic QSFP+ Transceiver for InfiniBand FDR/QDR/DDR/SDR,16G/10G/8G/4G/2G fiber channel , PCIe and SAS Applications. This transceiver is a high performance module for short-range multi-lane data communication and interconnect applications. It integrates four data lanes in each direction with 56 Gbps bandwidth. Each lane can operate at 14.0625 Gbps up to 100 m using OM3 fiber or 150 m using OM4 fiber. These modules are designed to operate over multimode fiber systems using a nominal wavelength of 850nm. The electrical interface uses a 38 contact edge type connector. The optical interface uses an 12 fiber MTP (MPO) connector. This module incorporates F-tone Networks proven circuit and VCSEL technology to provide reliable long life, high performance, and consistent service.QSFP+ SR4 is one kind of parallel transceiver. VCSEL and PIN array package is key technique, through I2C system can contact with module.
Features
● Four-channel full-duplex transceiver modules
● Transmission data rate up to 14.0625Gbit/s per channel
● 4 channels 850nm VCSEL array
● 4 channels PIN photo detector array
● Low power consumption <1.5W
● Housing isolated from connector ground
● 3.3V power supply voltage
● RoHS 6 compliant
● Hot Pluggable QSFP form factor
● Maximum link length of 100m on OM3 Multimode Fiber (MMF)and 150m on OM4 MMF
● Single MPO connector receptacle
● Case operating temperature
Commercial: 0 ~ +70℃
Industrial: -40 ~ +85℃
Applications
● InfiniBand FDR
● 16x Fibre Channel
● PCI-e3.0
● Proprietary High Speed Interconnections
● SAS 3.0
Absolute Maximum Ratings
Parameter |
Symbol |
Min |
Max |
Unit |
Supply Voltage |
Vcc |
-0.3 |
3.6 |
V |
Input Voltage |
Vin |
-0.3 |
Vcc+0.3 |
V |
Storage Temperature |
Tst |
-20 |
85 |
ºC |
Case Operating Temperature |
Top |
0 |
70 |
ºC |
Humidity(non-condensing) |
Rh |
5 |
95 |
% |
Recommended Operating Conditions
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Supply Voltage |
Vcc |
3.13 |
3.3 |
3.47 |
V |
Operating Case temperature |
Tca |
0 |
70 |
ºC |
|
Data Rate Per Lane |
fd |
2.5 |
14.0625 |
Gbps |
|
Humidity |
Rh |
5 |
85 |
% |
|
Power Dissipation |
Pm |
1.5 |
W |
||
Fiber Bend Radius |
Rb |
3 |
cm |
Electrical Specifications
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Differential input impedance |
Zin |
90 |
100 |
110 |
ohm |
Differential Output impedance |
Zout |
90 |
100 |
110 |
ohm |
Differential input voltage amplitude aAmplitude |
ΔVin |
300 |
1100 |
mVp-p |
|
Differential output voltage amplitude |
ΔVout |
500 |
800 |
mVp-p |
|
Skew |
Sw |
300 |
ps |
||
Bit Error Rate |
BR |
E-12 |
|||
Input Logic Level High |
VIH |
2.0 |
VCC |
V |
|
Input Logic Level Low |
VIL |
0 |
0.8 |
V |
|
Output Logic Level High |
VOH |
VCC-0.5 |
VCC |
V |
|
Output Logic Level Low |
VOL |
0 |
0.4 |
V |
Note:
1. BER=10^-12; PRBS 2^该邮件地址已受到反垃圾邮件插件保护。要显示它需要在浏览器中启用 JavaScript。.
2. Differential input voltage amplitude is measured between TxNp and TxNn.
3. Differential output voltage amplitude is measured between RxNp and RxNn.
Optical Characteristics
Table 3 - Optical Characteristics
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Notes |
|
Transmitter |
|||||||
Centre Wavelength |
λc |
840 |
850 |
860 |
nm |
- |
|
RMS spectral width |
∆λ |
- |
- |
0.65 |
nm |
- |
|
Average launch power, each lane |
Pout |
-7.5 |
- |
2.5 |
dBm |
- |
|
Difference in launch power between any two lanes (OMA) |
4 |
dB |
- |
||||
Extinction Ratio |
ER |
3 |
- |
- |
dB |
- |
|
Peak power, each lane |
4 |
dBm |
- |
||||
ransmitter and dispersion penalty (TDP), each lane |
TDP |
3.5 |
dB |
- |
|||
Average launch power of OFF transmitter, each lane |
-30 |
dBm |
- |
||||
Eye Mask coordinates: X1, X2, X3, Y1, Y2, Y3 |
SPECIFICATION VALUES 0.23, 0.34, 0.43, 0.27, 0.35, 0.4 |
Hit Ratio = 5x10-5 |
|||||
Receiver |
|||||||
Centre Wavelength |
λc |
840 |
850 |
860 |
nm |
- |
|
Stressed receiver sensitivity in OMA, each lane |
-5.4 |
dBm |
1 |
||||
Average power at receiver input, each lane |
-9.5 |
2.4 |
dBm |
- |
|||
Receiver Reflectance |
-12 |
dB |
- |
||||
Peak power, each lane |
4 |
dBm |
- |
||||
LOS Assert |
-30 |
dBm |
- |
||||
LOS De-Assert – OMA |
-7.5 |
dBm |
- |
||||
LOS Hysteresis |
0.5 |
dB |
- |
Note: 1.Measured with conformance test signal at TP3 for BER = 10e-12
Mechanical Dimensions
Ordering information
Part Number |
Product Description |
FTCQ-5X6-SR4 |
56Gb/s QSFP+ SR4, 100m on OM3 Multimode Fiber (MMF)and 150m on OM4 MMF,0ºC ~ +70ºC |
FTCQ-5X6-SR4I |
56Gb/s QSFP+ SR4, 100m on OM3 Multimode Fiber (MMF)and 150m on OM4 MMF,-40ºC ~ +85ºC |
北亿纤通 | F-tone Networks
企业邮箱: 该邮件地址已受到反垃圾邮件插件保护。要显示它需要在浏览器中启用 JavaScript。
企业手机:19081343401
企业电话:028-85255257
企业传真:028-85977702
注:本产品有全国产化型号可选
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.