Description
The F-tone Networks FTQD-4H-PSMDR4 is an Eight-Channel, Pluggable, Parallel, Fiber-Optic QSFP Double Density for 2x200 Gigabit Ethernet Applications. This transceiver is a high performance module for short-range multi-lane data communication and interconnection applications. It integrates eight data lanes in each direction with 8x26.5625GBd. Each lane can operate at 53.125Gbps up to 2km using G.652 SMF with KP-FEC. These modules are designed to operate over single mode fiber systems using a nominal wavelength of 1310nm. The electrical interface uses a 76 contact edge type connector. The optical interface uses a MPO16/MTP16 APC connector. The Common Management Interface Specification (CMIS) for QSFP DD modules. This module incorporates F-tone Networks Technologies proven circuit and EML technology to provide reliable long life, high performance, and consistent service.
Features
● 8 channels full-duplex transceiver modules
● Transmission data rate up to 53Gbps per channel
● 8x53Gbps PAM4 transmitter and PAM4 receiver
● 8 channels1310nm uncooled EML
● 8 channels PIN photo detector array
● Internal CDR circuits on both receiver and transmitter channels
● Power consumption <11W
● Hot Pluggable QSFP DD form factor and Compliant with CMIS 4.0
● Maximum link length of 2km G.652 SMF with KP-FEC
● MPO16 APC connector receptacle
● Built-in digital diagnostic functions
● Operating case temperature 20°C to +60°C
● 3.3V power supply voltage
● RoHS compliant(lead free)
Applications
● IEEE 802.3bs 200GBASE-DR4
Absolute Maximum Ratings
Parameter |
Symbol |
Min |
Max |
Unit |
Supply Voltage |
Vcc |
-0.3 |
3.6 |
V |
Input Voltage |
Vin |
-0.3 |
Vcc+0.3 |
V |
Storage Temperature |
Tst |
-20 |
85 |
ºC |
Case Operating Temperature |
Top |
20 |
60 |
ºC |
Humidity(non-condensing) |
Rh |
5 |
95 |
% |
Recommended Operating Conditions
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Supply Voltage |
Vcc |
3.13 |
3.3 |
3.47 |
V |
Operating Case temperature |
Tca |
20 |
60 |
ºC |
|
Data Rate Per Lane |
fd |
26.5625 |
GBd |
||
Humidity |
Rh |
5 |
85 |
% |
|
Power Dissipation |
Pm |
11 |
W |
Electrical Specifications
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Differential input impedance |
Zin |
90 |
100 |
110 |
ohm |
Differential Output impedance |
Zout |
90 |
100 |
110 |
ohm |
Differential input voltage amplitude |
ΔVin |
900 |
mVp-p |
||
Differential output voltage amplitude |
ΔVout |
900 |
mVp-p |
||
Skew |
Sw |
300 |
ps |
||
Bit Error Rate |
BER |
2.4E-4 |
- |
||
Near-end Eye Width at 10^-6 probability(EW6) |
0.265 |
UI |
|||
Near-end Eye Height at 10^-6 probability(EH6) |
70 |
mV |
|||
Far-end Eye Width at 10^-6 probability(EW6) |
0.20 |
UI |
|||
Far-end Eye Height at 10^-6 probability(EH6) |
30 |
mV |
|||
Near-end Eye Linearity |
0.85 |
- |
Note:
1. BER=2.4E-4; 该邮件地址已受到反垃圾邮件插件保护。要显示它需要在浏览器中启用 JavaScript。. Pre-FEC
2. Differential input voltage amplitude is measured between TxnP and TxnN.
3. Differential output voltage amplitude is measured between RxnP and RxnN.
Optical Characteristics
Table 3 - Optical Characteristics
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Notes |
Transmitter |
||||||
Centre Wavelength |
λc |
1304.5 |
-- |
1317.5 |
nm |
- |
Side-mode suppression ratio |
SMSR |
30 |
- |
-- |
dB |
- |
Average launch power, each lane |
Pout |
-5.1 |
- |
3 |
dBm |
- |
Optical Modulation Amplitude (OMA outer), each lane |
OMA |
-3 |
2.8 |
dBm |
- |
|
Transmitter and dispersion eye closure(TDEC),each lane |
TDEC |
3.4 |
dB |
|||
Extinction Ratio |
ER |
3.5 |
- |
- |
dB |
- |
Average launch power of OFF transmitter, each lane |
-30 |
dB |
- |
|||
Receiver |
||||||
Centre Wavelength |
λc |
1304.5 |
-- |
1317.5 |
nm |
- |
Receiver Sensitivity in OMA outer |
RXsen |
|
-6.6 |
dBm |
1 |
|
Stressed Receiver Sensitivity in OMA outer |
SRS |
-4.1 |
dBm |
1 |
||
Average power at receiver , each lane input, each lane |
Pin |
-8.1 |
3 |
dBm |
- |
|
Receiver Reflectance |
-12 |
dB |
- |
|||
LOS Assert |
-10 |
dBm |
- |
|||
LOS De-Assert – OMA |
-7.5 |
dBm |
- |
|||
LOS Hysteresis |
0.5 |
dB |
- |
Note:Measured with conformance test signal at TP3 for BER = 2.4E-4 Pre-FEC
Mechanical Dimensions
Ordering information
Part Number |
Product Description |
FTQD-4H-PSMDR4 |
QSFP DD, 2x200GBASE-DR4, 2km on Single mode Fiber (SMF),with DSP Power consumption <11W, MPO16(MTP16) APC connector. |
北亿纤通 | F-tone Networks
企业邮箱: 该邮件地址已受到反垃圾邮件插件保护。要显示它需要在浏览器中启用 JavaScript。
企业手机:19081343401
企业电话:028-85255257
企业传真:028-85977702
注:本产品有全国产化型号可选
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.